G23 2 Pin PL LED Lamp 5000K
Product Name: G23 2 pin PL LED lamp 5000K
Product Code: HSL-PL10WE
IP Rate: IP44
Power: 10 Watts
Base Holder: G23, GX23, 2G7,2GX7
Input Voltage: AC 85-265VAC 50/60Hz
Power Factor(PF): >0.9
LED driver: Isolated with glue protected
LED Source: SMD2835 Epistar chip
Lumen Flux: 1000LM +/-3%
Lumen Efficiency: 100lm/W
CRI (Ra): >80Ra (If only Ra>70, the lamp will be more brighter)
Beam Angle: 180 degrees
Cover Type: Clear / Frosted
Color Temperature: WW, NW,PW,CW
Materials: Aluminium body + Aluminium PCB + PC cover
G23 2 pin PL LED lamp 5000K
Features of 2 pin PL LED lamp:
1. Wide input 85-277v voltage range, applicable to any country or region
2. LED luminous efficiency is as high as more than 110 lm/w
3. Efficient heat treatment,Light maintain rate nearly 94%
4. Traditional E27 / g24 interface,Can directly replace incandescent lamp, energy-saving lamp
5. ultra-low power consumption
Q: What are the socket sizes used for traditional home lighting in the USA?
A: E27: A conventional pear shaped incandescent bulb uses an E27 socket base. The 27 means the socket diameter is 27 mm. This socket size has also been called a medium socket. Traditional indoor table lamps, ceiling fixtures, and bathroom fixtures use the E27 socket type. Recessed lighting fixtures typically found in the basement and kitchen also use the E27 socket type; however bulbs for recessed lighting are typically described as PAR20, PAR30, and PAR38. Outdoor flood lights and some porch lights also use the E27 base. These bulbs are 110v.
o E12: Most chandelier fixtures in the USA require use the E12 socket base. The diameter of this socket is 12 mm. Also many porch light fixtures use the E12 socket base. These bulbs are 110v.
o GU10: The GU10 lamp is normally used for small track lights that have traditionally used 25w and 40w halogen lamps. The distance between the center of the pins on the bottom of the lamp are 10 mm. These bulbs are 110v. The pin has a head on the end.
o MR16: The MR16 base is also called the GU5.3. The distance between the pins is 5.3 mm. The pins are straight. MR16 bulbs are normally used for low voltage (12v) applications.
Q: Can we trust your product quality?
A: Every entering our catalogue product will be tested according to strictest quality test standard and make sure your profit won't be hurt by quality.