LED Corn Light 60W
Product Name: LED Corn Light 60W
Product Code: HSL-CN60W
IP Rate: IP65
Power: 60 Watts
Base Holder: E40 / E39 / E26 / E27
Input Voltage: AC 85-265VAC 50/60Hz
Power Factor(PF): >0.9
LED driver: Isolated with glue protected
LED Source: SMD5730 Epistar chip OR SMD5630 Samsung chip
Lumen Flux: 6900LM +/-3% OR 8500LM +/-3%
Lumen Efficiency: 120lm/W OR 150lm/W
CRI (Ra): >80Ra (If only Ra>70, the lamp will be more brighter)
Beam Angle: 360 degrees
Cover Type: Clear / Frosted
Color Temperature: WW, NW,PW,CW
Materials: Aluminium body + Aluminium PCB + PC cover + Fireproof PC base
LED Corn Light 60W
1, Long life: normally use, life up to 50000 hours. Greatly reduce the change of frequency;
2, High efficiency and energy saving 90% compare incandescent lamp;
3, High luminous efficiency: 90% of its electricity into visible light, only 20% of ordinary incandescent electric energy into visible light;
4, Heat radiation easy,epoxy resin encapsulation,light-emitting diode light source;
5, Special circuit designed,avoid single Led fault impact whole tube efficiency;
6, CRI higher:color resume fine, insight clearance,no distortion;
7, Cover choose environmental protection material PC for recycled;
8, High security:all drivers are used when the high pressure isolation driver;
Q: What type of voltage and current do LED lights require to operate?
A: Conventional incandescent lamps are made to operate on standard AC power. Descrete LED chips themselves are designed to operate on DC current typically in the 350 mA range. As a result LED bulbs are designed with built in AC to DC converters that supply the correct current needed for the specific LED chips. LED lights may be used in place of traditional incandescent lamps without changing the fixture. Please note that most LED lights are not designed to be used with dimmers. Do not install an LED bulb into a dimmer controlled circuit with a properly designed LED lamp. Flourescent Tube lamps operate with a specific ballast. To install a T8 LED tube replacement, the flourscent ballast fixture must be removed or bypassed to provide the standard direct connection of the 110 VAC power to the T8 LED tube. One end of the tube receives the positive and one end receives the nuetral.
Q: LEDs are more expensive than other lighting options. Why?
A: LEDs can operate as standalone devices, but when grouped or clustered they require additional steps to operate properly. LEDs need proper components such as a circuit board, driving components and some cases and housings to endure the elements. LED circuits can be designed rapidly, but to ensure that they operate correctly and for long periods of time they require testing.